CABLE CLAMPS COMBINE CLEVER DESIGN WITH EASE OF ASSEMBLY

The clamps are moulded from black polyamide 6GV and are suitable for use inside or outside, even in hostile operating environments. They are also resistant to grease, oil, UV and ozone radiation, and can accommodate cable loads up to 600A and function in temperatures ranging from -40° to +120°C.

The KHF, single aperture clamps come in a wide selection of sizes, and are suitable for single insulated cable diameters ranging from 16mm up to 100mm. Clamp footprint is compact, ranging from 66 by 21mm, up to 182 by 80mm. Larger clamps are also available that accept multiple cables. These can be configured in three-cable triangular or four-cable diamond arrangements within a single enclosure aperture. The triangular cable formation emits a magnetic field level of no more than 100 micro Tesla at 20cm radius, and all clamps are rated to an impressive short circuit resistance load of 25kN.

Additionally, the K series clamp is designed for use with insulated power cables installed in series or multiple cable layers. These can be arranged in a wide combination of configurations, for example, with two blocks to accept 3-4 cables (10-32mm diameter), in flat runs on either horizontal or vertical planes, or with three tiered or layered blocks to accept 6-8 cables.

Polyamide cable clamps can be supplied for cable centre settings of 38, 41, 44 or 65mm, with optional clamp sizes to provide alternative cable row spacing. All clamps come with mounting plates incorporating stainless steel stud bolts, nuts and washers.