Hopper helps operators easily adjust abrasive flow

19th August 2016
Source: Jet Edge
Posted By : Joe Bush

The variable aperture Permalign V-Series Mini Hopper from Jet Edge increases abrasive waterjet cutting productivity and profitability by allowing waterjet operators to easily make adjustments to abrasive flow, minimising abrasive consumption.

The Permalign V-Series Mini Hopper’s water resistant design helps prevent annoying abrasive clogs that can cause stoppages and scrap out expensive material. Built for the harsh abrasivejet environment, the Permalign V-Series Mini Hopper does not require an enclosure, allowing for much cleaner operation. The mini-hopper is infinitely adjustable between 0.10lbs per minute to 2lbs per minute and features improved venting of excess abrasive.

The Permalign V-Series Mini Hopper is available as a replacement part for all Jet Edge abrasive waterjet cutting systems.


You must be logged in to comment

Write a comment

No comments




Sign up to view our publications

Sign up

Sign up to view our downloads

Sign up

Electronic Specifier Expo 2020
1st September 2020
United Kingdom Virtual Event
RIA Robotics Week 2020
8th September 2020
United Kingdom Virtual Event
Autonomous Mobile Robot Conference 2020
26th October 2020
United Kingdom Virtual Event
AI & Smart Automation Conference 2020
28th October 2020
United Kingdom Virtual Event
Advanced Engineering 2020
4th November 2020
United Kingdom NEC, Birmingham