Multifunction USB Data Acquisition - DT9818

This embedded board offers all the features of a high performance data acquisition module without any limitations. The DT9818 board provides 8 or 16 analog inputs, 2 analog outputs, 16 digital I/O lines, 2 counter timers and allows simultaneous operation of all subsystems at throughput rates up to150kHz. This board-only OEM version allows the user to embed data acquisition capability directly into their USB system. Many software choices are available for application development from ready-to-measure programs like Measurement Applets and quickDAQ, to full graphical programming with Measure Foundry rapid application development builder.

Key Design Features of the DT9818:
• Ultimate flexibility with 16 analog inputs, 2 analog outputs, 16 digital I/O (8 in / 8 out), and two 32-bit counter timers, all running on USB power
• Simultaneous subsystem operation of all subsystems at throughput rates up to 150 kHz
• 500 volt galvanic isolation prevents ground loops, maximizes analog signal integrity, and protects the computer
• Runs on USB power, no external power supply needed
• Generate ultra-smooth sine, rectangle, triangle, or other waveforms with the analog outputs with less than 1.0nV/sec glitch energy
• True 16-bit resolution for both the analog input and analog output subsystems
• Independent clocking and triggering for input and output subsystems for maximum flexibility
• Designed for low noise to protect signal integrity