Valve Components Cleaned Efficiently and Cost Effectively

In contrast, the programmable Elba has the ability to use three types of cleaning cycle when a batch of components is in the machine. First, to prevent components clashing together, the basket is held stationary in its home position while jets run around it, spraying water from every angle. This is ideal for cleaning light, simple parts, perhaps with turned diameters that need to be protected.

A second cleaning program involves rocking the basket through ±10 degrees, affording extra access to components for better cleaning, while still avoiding contact between them and potential damage.

Third, one or several larger parts are fixed into a basket, which is rotated through 360 degrees. A patented feature of the machine is the ability to adjust the movements of the holding basket and spray jets individually, allowing them to rotate in the same or opposite directions. Such cycles provide excellent penetration into the most awkward areas of particularly complex valve components for the removal of oil, coolant, tapping grease, swarf and other contaminants from the previous machining processes.

Components range from 25 to 500 mm long and are produced from a variety of metals, mainly stainless steel, carbon steel, aluminium and brass. Stainless steel parts undergo a detergent wash and rinse cycle at 50ºC, followed by compressed air drying at 70ºC within the machine. Processing of the other materials omits the rinse stage for speed, as all components are in any case cleaned ultrasonically before assembly.

Richard Betts, production engineer at Thompson Valves in charge of the cleaning section, commented, We chose the Elba for a combination of reasons based on its compactness, functionality and competitive price, which was a full £30,000 less than another model we looked at.

The machine is quick to install, as the integral condensing system avoids having to fit extraction.

It is also easy to operate using our suite of nine installed programs, each of which takes typically five minutes.

Overall, it supports the effective cleaning of components for the manufacture of valves used for safety-critical applications in the nuclear, oil and gas, petrochemical and marine markets, which are the sectors that we mainly serve.