The ITA-1 (Click-R Clack-R) analogue strain gauge amplifier has been unveiled by Interface Force Measurements. The amplifier is used to convert a sensor’s millivolt signal into an analogue signal for display or data acquisition. The product is connected to the sensor in line via a 5-pin, M12 connector.
The ITA-1 can be connected to any force, strain, torque or pressure sensor that supplies a millivolt output signal, either voltage or current.
When supplied with an Interface load cell or torque transducer, the ITA-1 comes factory configured to the correct output however, set-up can be modified using the tare and scale cables.
It is also TEDS enabled, so enabling easy configuration with TEDS-equipped load cells.
Write a comment
No comments